WeldForce KWF 5200, 300, 200S, 300S / 0612 – 3© Kemppi oy
1. PREFACE
1.1. INTRODUCTION
Congratulations on having purchased this product. Properly installed Kemppi products should
prove to be productive machines requiring maintenance at only regular intervals. This manual is
arranged to give you a good understanding of the equipment and its safe operation. It also contains
maintenance information and technical specications. Read this manual from front to back before
installing, operating or maintaining the equipment for the rst time. For further information on
Kemppi products please contact us or your nearest Kemppi distributor.
The specications and designs presented in this manual are subject to change without prior
notice.
In this document, for danger to life or injury the following symbol is used:
Read the warning texts carefully and follow the instructions. Please also study the Operation safety
instructions and respect them when installing, operating and servicing the machine.
1.2. PRODUCT INTRODUCTION
Kemppi WeldForce KWF is wire feeder designed for demanding professional use.
Introducing units KWF 200 and KWF 300, members of our product family designed to suit 200-
mm and 300-mm wire reel requirements. Units KWF 200S and KWF 300S are identical to the
parent unit’s, but equipped with less extensive range of functions.
Operations of wire feed unit are controlled and adjusted with microprocessor.
This manual provides instructions on the start-up of the KWF 200, KWF 300, KWF 200S and
KWF 300S MIG units and the functions of the wire feed unit.
This equipment’s electromagnetic compatibility (EMC) is designed for use in an
industrial environment. Class A equipment is not intended for use in residential location
where the electrical power is provided by the public low-voltage supply system.
To Next Page
Loading...
Need help?
General
