Kenmore 15243 - Changing Presser Foot; To Remove; To Attach; Presser Foot Types

Changing Presser Foot
(_ Lever
(_ Groove
@Pin
* To remove
Turn the handwheel toward you to raise the needle to its
highest position, Raise the presser foot.
Press the lever(_on the back of the foot holder, The
presser foot will drop off.
* To attach
Place the presser foot so that the pin (_on the foot lines
up directly below the groove (_of the foot holder,
Lower the foot holder to lock the foot in place,
Presser Foot Types
. Zigzag foot
Use this foot for both straight and zigzag ....
For: Straight stitch
Topstitching
Basic zigzag
Satin stitching
Monogramming
Applique
Bar tacking
Button ....................
Overcasting 8ti_:_ (,page 48) ..................
Multiple zig_ _ :ii_ch 48)
so)
..... 50)
_ili_i_!i!ii!i!ii!i!ii!i!ii!i!ii!i!ii!i!ii!i!ii!i!ii!i!ii:i_
Sliding buttonhole foot
Use this foot for manual buttonhole making. It is marked
to help you measure a buttonhole accurately.
For: Buttonhole sewing (page 54)
• Zipper foot
The edge of the foot guides the zipper and keeps the
seam straight.
For: Zipper sewing (page 36)
* Hemmer foot
This special foot is for sewing a rolled hem. The curl of
the foot helps to form a hem at a constant width,
For: Rolled hem (page 38)
%
J
12