TROUBLESHOOTING
First try the soRufions suggested here
for assistance and to possibRy avoid a service call.
Dry spots on Road High speed spins extract more
after cycle moisture than your previous washen
Check for proper water suppRy.incorrect or wrong
wash or rinse
temperatures
Energy saving controlled
wash temperatures.
Load not rinsed Check for proper water suppRy.
Using too much detergent.
Washer not Roaded as recommended.
Using too Row a Load Size/water ReveR
seRecfion.
Sand, pet hair, lint, Heavy sand, pet hair, lint, and
etc. on load after detergent or bleach residues may
washing require additionaR rinsing.
Load is tangling Washer not loaded as recommended.
Not cleaning or
removing stains
Using too low a Load Size/water level
selection.
Washer not loaded as recommended.
The high spin speeds combined with air flow during the final spin
can cause items near the top of the load to develop dry spots
during the final spin. This is normal.
Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached to both washer and faucet, and
have both hot and cold water flowing to inlet valve.
Check that inlet valve screens are not dogged.
Remove any kinks in hoses.
Energy Star washers use coder wash temp than your previous
washer. This includes cooler hot and warm washes. All rinses are
cold.
Make sure hot and cold inlet hoses are not reversed.
Both hoses must be attached and have water flowing to the
inlet valve.
-Both hot and cold water faucets must be on.
inlet valve screens on washer may be dogged.
Remove any kinks in the inlet hose°
The suds from too much detergent can keep washer from
operating correctly. Always measure detergent and follow
detergent directions based on Joad size and soil level.
The washer is less efficient at rinsing when load is tightly packed.
Load garments in loose heaps evenly around the basket wall.
Load with dry items only,
Use cycle designed for the fabrics being washed.
Add only 1 or 2 garments after washer has started.
Choose a Load Size (water level) that matches the load being
washed.
Add a 2nd Rinse to the selected cycle.
Using too low a Load Size/water level
selection.
_., J
See _Using Your Washer" section.
Select a cycle with a slower wash action and spin speed;
however_ items will be wetter than those using a higher
speed spin.
Load garments in loose heaps evenly around the basket wall.
Reduce tangling by mixing types of load items. Use the
recommended cycle for the type of garments being washed.
Choose a Load Size (water level) that matches the load being
washed.
Washer is less efficient at cleaning when load is tightly packed.
Load garments in loose heaps evenly around the basket wall.
Load with dry items only.
Add only 1 or 2 garments after washer has started.
Choose a Load Size (water level) that matches the load being
washed.
14
To Next Page
Loading...
Need help?
General