TROUBLESHOOTING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
f
First try the solutions suggested here for assistance and to possibly avoid a service call.
Jf you experience
Washer won't run Check proper eRectricaR suppRy.
or fill, washer stops
working (cont.)
Washer not draining//
spinning, Roads are
stiH wet
Normal washer operation.
PRug power cord into a grounded 3 prong outlet.
Do not use an extension cord.
Ensure there is power to outlet.
Reset a tripped circuit breaker_ RepRace any brown fuses.
NOTE: if probRems continue, contact an eRectrician.
Ud must be closed for washer to run.
Washer wiRRpause during certain phases of cycle.
Do not interrupt cycle.
Washer may be stopped to reduce suds_
The washer senses the dry load with short spins that may take 2 to
3 minutes before water is added.
Washer not loaded as Remove several items, rearrange load evenly in basket and add
recommended, detergent. Close lid and press START//PAUSE//Unlock Lid.
Not using HE detergent or using too
much HE detergent.
Empty pockets and use garment bags
for small items.
Use a cycle with a low spin speed.
Washer not loaded as recommended.
Check plumbing for correct drain hose
installation. Drain hose extends into
standpipe farther than 4.5" (114 ram).
Do not add more than I or 2 additional items after cycle has
started.
Do not add more water to the washer.
Only use HE detergent. Suds from regular detergents can slow or
stop the washer. Always measure detergent and follow
detergent directions based on your load requirements.
To remove suds, cancel cycle. Select Rinse!!Spin. Press START//
PAUSE!!Unlock Lid. Do not add more detergent.
Small items may have been caught in pump or between basket
and tub, which can slow draining.
Cycles with lower spin speeds remove less water than cycles
with high spin speeds. Use the recommended cycle//speed spin
for your garment. To remove extra water in the load, select Drain//
Spin. Load may need to be rearranged to allow even
distribution of the load in the basket.
Reduce load size to improve water removal. A fighfly packed
load may not allow the washer to spin correctly, leaving the
load wetter than normal. See "Using Your Washer" for loading
recommendations
Check drain hose for proper installation. Use drain hose form
and securely attach to drainpipe or tub. Do not tape over drain
opening° Lower drain hose if the end is higher than 96" (2.4 m)
above the floor. Remove any dogs from drain hose.
J
14
To Next Page
Loading...
