CONTROL PANEL AND FEATURES
O WASH TEMP
Temperature Control senses and maintains uniform water
temperatures by regulating incoming hot and cold water.
Select a wash temperature based on the type of fabric and
soils being washed. For best results and following the garment
label instructions, use the warmest wash water safe for your
fabric.
* Warm and hot water will be cooler than what previous
washer provided.
* Even in a cool and cold water wash, some warm water
may be added to the washer to maintain a minimum
temperature.
CYCLEOPTIONS
The following options may be added to most cycle.
See "Cycle Guide" for additional details.
RINSE
This option can be used to automatically add a second
rinse to most cycles.
FABRIC SOFTENER
This option must be set to "On" Jf using fabric softener
during a cycle, it ensures that fabric softener is added
at the correct time in the rinse for even distribution.
STAINBOOST
This option provides enhanced cleaning action for tough
stains, it wJJJadd additional spin and soak time to
the cycle.
WASH CYCLE
Use the Wash Cycle to select available cycles on your washer.
Turn the knob to select a cycle for your laundry load. See
"Cycle Guide" for detailed descriptions.
O START/PAUSE/UNLOCK LID
Press to start the selected cycle; press again to pause the
cycle and unlock the lid.
NOTE: if the washer is spinning, it may take several minutes
to unlock the lid. Press CANCEL Hold 3 sec. to cancel a cycle.
CYCLE STATUS LIGHTS
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
® ® ® ® ® ®
The Cycle Status Lights show the progress of a cycle. At each
stage of the process, you may notice sounds or pauses that
are different from traditional washers.
SENSING
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
O ® ® • • ®
When the START/PAUSE/Unlock lid is pressed, the washer
will first perform a self-test on the lid lock mechanism. You
will hear a click, the basket will make a slight turn, and the
lid will unlock briefly before locking again.
Once the lid has locked the second time, the washer will
use short, slow spins to estimate the load size. these sensing
spins may take 2 to 3 minutes before water is added to
the load. The washer will then move the load briefly, pause
to allow water to soak in to the load, and resume adding
water. This process may repeat until the correct amount
of water has been added for the load. You may also hear
water flowing through the dispenser, adding detergent to
the load.
NOTE: The sensing light may also come on during the
Soak and Wash portions of the cycle. This is normal.
WASH
Cycle Lid
Sensing Wash Rinse Spin Complete Locked
O O ® • ® ®
You will hear the washplate moving the load. Unlike
traditional washers, the load is not covered with water.
Low-water cleaning means concentrated cleaning. Rather
than diluting detergent as done in an agitator-style washer,
this washer delivers the detergent directly to the soils. The
motor sounds may change at different stages in the cycle.
The wash time is determined by the selected soil level.
To Next Page
Loading...
Need help?
General