EasyManua.ls Logo

Kenmore 253.25031 - User Manual

Kenmore 253.25031
10 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
P/N 2020266A0280
Kenmore®
Sears Brands Management Corporation
Hoçman Estates, IL 60179 U.S.A.
www.kenmore.com
www.sears.com
English / Français
Use&CareGuide
Manuel d’utilisation et d’entretien
Models/Modèles: 253.25031, 253.25032, 253.25033
'HKXPLGLoHU
'ÑVKXPLGLoFDWHXU

Questions and Answers

  • E
    earldanielsJul 31, 2025
    What to do if my Kenmore 253.25031 does not operate?
    • B
      Benjamin HolmesJul 31, 2025
      If your Kenmore Dehumidifier isn't operating, first, ensure it's properly plugged into the wall outlet. Check for a blown house fuse or a tripped circuit breaker and replace or reset it. If the dryness level you selected has been reached, the dehumidifier automatically shuts off; select 'CONTINUOUS' if you want to remove more moisture. Make sure the bucket is correctly installed and not full. Also, ensure the dehumidifier is turned on and that the 'BUCKET FULL' light is not illuminated; if it is, empty and reinstall the bucket.
  • J
    Jonathan MillerAug 6, 2025
    Why does frost appear on the coils of my Kenmore Dehumidifier?
    • Y
      ybenderAug 7, 2025
      Frost may appear on the coils above the bucket or drip tray of your Kenmore Dehumidifier if the unit has been turned on recently. This is normal due to refrigerant rushing through the coil and should disappear within 60 minutes. If the room temperature is too low, ensure it is higher than 5 °C (41 °F) for satisfactory operation.
  • R
    Richard RamirezAug 12, 2025
    Why does my Kenmore 253.25031 Dehumidifier run too much?
    • M
      millermichealAug 13, 2025
      Your Kenmore Dehumidifier might be running too much because windows or doors near the unit are open to the outdoors—try closing them. The area you're trying to dehumidify could be too large, so consult your dealer to check if the unit's capacity is adequate. Also, ensure that air movement through the dehumidifier isn't blocked, and clean the grill with a vacuum cleaner brush attachment. Finally, if the dehumidifier is in CONT mode, use the humidity button or knob to set a higher relative humidity level.
  • B
    Bradley NunezAug 18, 2025
    What to do if my Kenmore 253.25031 Dehumidifier is operating but the room is not dry enough?
    • Z
      zsullivanAug 18, 2025
      If your Kenmore Dehumidifier is running but the room isn't dry enough, the humidity setting might be too high. Press the HUMIDITY button or rotate the knob to a lower setting, or choose CONTINUOUS for maximum dryness. If the dehumidifier was recently installed or restarted, it will take longer to dry the room air, especially if the moisture level is high. Ensure the dehumidifier has sufficient clearance and that airflow to the front grill isn't blocked. The unit won't work well if the room temperature is below 5 °C (41 °F). It may also be running too much, so refer to the solutions for that problem.
  • J
    Jamie McguireAug 25, 2025
    How to fix fan noise in Kenmore 253.25031 Dehumidifier?
    • M
      Mrs. Cheryl Strong MDAug 25, 2025
      The fan noise you hear from your Kenmore Dehumidifier is normal; it's simply the sound of air moving through the unit.

Summary

Kenmore Dehumidifier Limited Warranty

General Warranty Coverage

Describes the warranty coverage for defects in materials or workmanship.

Warranty Exclusions

Lists items and conditions not covered by the warranty.

Repair Policy

States that repairs within the warranty period are covered until the end of the original period.

Warranty Disclaimers

Outlines warranty limitations and legal rights.

Customer Responsibilities

Summarizes customer duties for warranty validity and proper use.

Warranty Service Procedures

Provides contact number for warranty service.

Applicable Warranty Periods

Details warranty duration for parts and labor.

Service Type and Location

Explains that service is "carry-in" at designated locations.

Proof of Purchase Requirement

States that proof of purchase is needed for warranty coverage.

Read and Save These Instructions

Record Model and Serial Numbers

Instructions to record model and serial numbers for future reference and service.

Important Safety Instructions

For Your Safety

Advises against storing flammable liquids near the unit and discards water safely.

Child Safety Precautions

Warns about children playing with packing materials or unattended operation.

Electrical Safety Information

Details grounding plug requirements and safe electrical connections.

Selecting a Location

How It Works

Dehumidifier Features Overview

Fault Codes

Explains fault codes like "AS" or "ES" indicating sensor failure.

Removing Collected Water

Continuous Drainage Setup

Details setup for continuous drainage using a garden hose.

Care and Cleaning

Filter Maintenance

Instructions on how to remove, wash, and reinstall the filter.

Cabinet Cleaning

Guidance on cleaning the unit's exterior cabinet and grill.

Water Bucket Cleaning

Instructions for cleaning the water collection bucket.

Power Cord Storage

Dehumidifier Troubleshooting Guide

Dehumidifier Does Not Operate

Lists checks for when the dehumidifier fails to start or operate.

Dehumidifier Runs Too Much

Provides reasons and solutions for the unit running excessively.

Room Not Dry Enough

Addresses situations where the room remains humid despite operation.

Frost on Coils

Explains the occurrence of frost on internal coils and its causes.

Fan Noise Issues

Discusses normal fan noise during operation.

Kenmore 253.25031 Specifications

General IconGeneral
BrandKenmore
Model253.25031
CategoryDehumidifier
LanguageEnglish

Related product manuals