Operating instructions
Other Features
Drying Rock
Use the drying rack to dry items which should not be
tumble dried. Fold down the metal support on the back
of the rack and slowly extend the rack until the lock tabs
click into place. Insert the rack into the dryer drum, resting
the back support on the moisture sensor bars and the front
legs on each side of the lint filter slot.
1
rear
front
legs
moisture sens-
ing bars
Place items to be dried on top of the rack, leaving space
between items and not allowing them to hang over the
sides or through the holes. The weight should not exceed
10 ibs (4.5 kg). Select Timed Dry with Air Fluff option for
items containing plastic, foam rubber, rubber-like materi-
als, feathers or down.
When items are dry, remove the rack, push the two center
tabs to collapse the rack and fold up the back support.
Store the drying rack in a convenient location.
Reversible Door
Your dryer is equipped with a reversible door. The door
can be hinged on the right or left side.
For step-by-step instructions on DOOR REVERSAL, refer
to the installation instructions supplied with this dryer.
Status indicators
f Stalus
The estimated total cycle time will be displayed when the
cycle is selected. The time may increase during Auto Dry
cycles if clothing is overly damp. The estimated remain-
ing cycle time is displayed during the cycle. The following
indicators may be lighted during the cycle:
e
e
e
e
e
e
Wet
Damp
Cooling
Wrinlde Guard
Clean Lint Filter
- shown in LED display (see "Check Exhaust",
next page)
Various other codes in the LED may alert you to
operating conditions that you can correct yourself
before calling service. See "Avoid Service Checklist"
for detail concerning these alert codes.
12
To Next Page
Loading...
Need help?
General