IIIIIIIIIIIH I I I
Replacement and Care of Filters
WARNING: To avoid shock or injury
from moving parts, always unplug
humidifier before removing or
replacing any parts.
ii H
CAUTION: To help retard bacteria
growth and keep maximum efficiency,
the filters should be replaced at least
once a season, or more often under
hard water conditions. Use Sears
re co mmended replacement filter.
All filters may be rinsed in clear water
only. Take care not to damage paper.
To replace the evaporative wicking filters
in your Kenmore Quiet Comfort I1 humidi-
fier, follow the instructions below.
1. Unplug humidifier, and proceed to
clean.
Before removing the filters, we recom-
mend moving the humidifier to an area
where floor coverings are not suscep-
tible to water damage, i.e. kitchen or
bath areas.
2. To remove parts
Remove the fan assembly by opening
the pivoting lid. Grasp the fan assem-
bly front center and rear center. Lift off
and set aside on a clean flat surface.
The filter assemblies are now accessi-
ble. Remove water bottles and set
aside.
3. Lift filter housings out of cabinet and
place where you may work on them
comfortably. With a soft, absorbent
cloth remove any remaining water or
loose mineral deposits not trapped in
the filter from the humidifier cabinet.
4. To open filter housing for easy access
to filters.
a. Deflect the two vertical tabs on top
of filter housing. Lift top cover off of
the filter housing and set aside.
b. Remove the two filters and dispose
of properly. Clean internal parts of
humidifier per the "Cleaning of
Humidifier" section of your owner's
manual.
To Next Page