29
START YOUR E-BIKE:
Turn on the battery using the on/off switch. The switch is located on the left side of the
frame - opposite the charging port.
Then press the ON/OFF BUTTON on the monitor display for 3 seconds. The monitor display
will turn on.
Once the bike and monitor display are ON, verify that the Battery Charge Meter shows
sufficient charge for your ride. If the battery does not have sufficient charge for your ride,
please refer to instructions on how to charge the battery.
Be sure to turn the battery power off when not in use or while recharging.
START YOUR RIDE:
Once you begin riding, you can choose the appropriate assistance level using the
INCREASE MOTOR ASSIST [+] or DECREASE MOTOR ASSIST [–] buttons on your display.
The motor will assist you once you start pedaling. There are 3 levels of assistance on the
display.
NOTES DURING RIDING:
Frequent braking and again accelerating will deplete the battery faster. The motor will stop
assisting once you stop pedaling. Your e-bikes rated maximum load is 220lbs (100kg)
including the rider, do not overload.
WARNING: When stopped, turn off the battery in case the crank arm keeps turning
while you push the bike. The motor would start suddenly which may lead to an accident.
FOR YOUR SAFETY, PLEASE MAINTAIN AND CLEAN YOUR E-BIKE REGULARLY.
OPERATING PROCEDURES
To Next Page
Loading...
