Need help?Do you have a question about the Kentec Electronics Sigma XT Plus and is the answer not in the manual?
General| Type | Fire Alarm Control Panel |
|---|---|
| Approval | EN54-2, EN54-4 |
| Display | LCD |
| Touchscreen | No |
| Storage Temperature | -10°C to +50°C |
| Enclosure Rating | IP30 |
| Power Supply | 24 V DC |
| Humidity | Up to 95% RH non-condensing |
| Communication Ports | RS-485 |
Ensures safe operation and installation, adhering to regulations and manufacturer advice.
Details correct placement and fixing methods for the control panel enclosure.
Step-by-step guide for safely removing the fire detection equipment chassis.
Guidelines for connecting field wiring to the control panel circuit boards.
Instructions for detection zone, sounder circuits, and intrinsically safe barrier wiring.
Details for connecting extinguishant outputs and monitored inputs.
Connecting external equipment to control panel functions via remote terminals.
Information on the auxiliary 24V DC outputs for extinguishant modules.
Details on relay contacts for local control, signalling, and system integration.
Procedure for connecting and addressing status units and ancillary boards.
Steps for adding or removing status units and ancillary boards from the system.
Setting configuration options for the detection section, including I.S. barrier settings.
Configuring module language, output modes, activation, delays, and release parameters.
Describes normal panel status, access levels, and basic operations.
Managing zones, sounders, and delays in the detection section.
Configuring and disabling outputs and functions on extinguishant modules.
Describes single/double zone fire conditions and silencing alarms.
Details common faults like zone, sounder, power, and system faults.
Covers module faults, lamp tests, hold/release conditions, and manual operations.
Watchdog, processor reset, and write enable switch for the detection section.
Watchdog, processor reset, write enable switch, and terminate function for modules.
Addressing modules and understanding internal fault indications.
Details power supply ratings, battery capacity recommendations, and loading considerations.
Routine maintenance procedures, battery testing, and PCB replacement guidance.
Information regarding the CE mark and its implications for the control panel.
Steps for initial setup, configuration, and testing of the control panel system.
To Next Page
