Need help?Do you have a question about the Kentec Electronics Sigma XT K11031M2 and is the answer not in the manual?
Essential safety guidelines for installation and use, emphasizing compliance with regulations and proper handling.
Instructions for physically mounting the control panel on a dry, flat surface at eye height.
Specific wiring requirements for solenoids, including resistance and suppression diodes.
Wiring details for igniting actuators, including series connection and resistors.
Procedure for setting up the extinguishant monitoring circuit, including adjustment.
Procedure for adding new status units and ancillary boards to the system.
Procedure for removing status units and ancillary boards from the system.
How the panel indicates and responds to a single zone fire condition.
Details on the panel's response to a second fire condition, leading to extinguishant release.
How to activate manual release and its operational response.
Procedure for silencing or sounding alarms using the panel buttons.
How zone faults are indicated on the panel.
How sounder circuit faults are indicated on the panel.
How power supply failures are indicated on the panel.
Indicates a system fault, often due to configuration issues.
General fault indicator that illuminates under various fault conditions.
Describes the hold condition and its effect on the extinguishant release sequence.
Indicates when the extinguishant has been released based on pressure switch input.
Indicates low pressure in the extinguishant cylinder, potentially a fault.
How to disable individual zones, affecting fire/fault reporting.
Requirements for storing configuration changes during commissioning.
General| Brand | Kentec Electronics |
|---|---|
| Model | Sigma XT K11031M2 |
| Category | Control Panel |
| Language | English |
To Next Page
