Man-1450EN Rev. 04
Sigma ZXT Quick Start Guide
Safety
Suppliers of articles for use at work are required to ensure as reasonably as is practical that the article will be safe
and without risk to health when properly used. An article is not regarded as properly used if it is used 'without regard
to any relevant information or advice' relating to its use made available by the supplier.
This product should be installed, commissioned and maintained by trained service personnel in accordance with the
following:
(i) Regulations for electrical equipment in buildings specific to the country of use.
(ii) Codes of practice
(iii) Statutory requirements
(iv) Any instructions advised by the manufacturer.
Installers of this product are required to take such steps as necessary to ensure that all appropriate information and
training is provided to anyone concerned with its use.
This equipment is designed to operate at 230V AC 50/60Hz mains supplies, class 1 construction. As such it must
be connected to a protective earthing conductor in the fixed wiring of the installation, failure to ensure that all con-
ductive accessible parts of this equipment are adequately bonded to the protective earth will render the equipment
unsafe.
A readily accessible double pole disconnect device meeting the requirements of the relevant electrical safety regu-
lations specific to the country of use, which disconnects live and neutral simultaneously shall be incorporated in the
fixed wiring.
This equipment is certified as environmental class A and therefore designed for indoor use only at temperatures
between -10°C and +45°C with a maximum relative humidity of 95%. The IP rating for the enclosure is IP30.
Operation outside of these limits may render the equipment unsafe.
To Next Page
Loading...
