Kenwood DPX-3070 User Manual

English
|
9
General features











  
Power
Turning ON the Power
Press the [SRC] button.
Turning OFF the Power
Press the [SRC] button for at least 1 second.
Selecting the Source
Press the [SRC] button.
Source required
Source required
Display
Display
Display
Tuner
"TUNER"
Tape
Tape
"TAPE"
CD
"CD"
External disc (Optional accessory)
External disc (Optional accessory)
"CD CH"
Auxiliary input
Auxiliary input
"AUX"
Standby (Illumination only mode)
Standby (Illumination only mode)
"STANDBY"
Volume
Increasing Volume
Press the [
5
] button.
Decreasing Volume
Press the [
∞
] button.
Attenuator
Turning the volume down quickly.
Press the [ATT] button.
Each time the button is pressed the Attenuator
turns ON or OFF.
When it’s ON, the "ATT" indicator blinks.
ATT indicator
1.DPX-MP4070MUS.indd 04.3.12,3:00PM9

Kenwood DPX-3070 Specifications

Audio Specifications

frequency response	10Hz~20kHz (±1dB)
total harmonic distortion	0.01% (1kHz)
S/N ratio	100dB (1kHz)

Radio Specifications

frequency range	87.5MHz~108.0MHz (50kHz)
channel space selection	50kHz/200kHz
usable sensitivity	9.3dBf (0.8µV/75Ω)

Amplifier Specifications

maximum power	50W x 4
full bandwidth power	22W x 4 (at less than 1% THD)
preout level	1800mV/10kΩ

Cassette Specifications

tape speed	4.76cm/sec.
frequency response	20Hz~20kHz (±1dB)
wow & flutter	0.1% (WRMS)

General Specifications

operating voltage	14.4V (11V~16V)
current consumption	10A
installation size	178 x 100 x 155 (mm)