EasyManuals Logo

Kenwood FP540 Series User Manual

Kenwood FP540 Series
11 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #3 background imageLoading...
Page #3 background image
safety
Read all instructions.
The blades and discs are very sharp, handle
with care. Always hold the knife blade
by the finger grip
at the top, away from the cutting
edge, both when handling and
cleaning.
Always remove the knife blade before pouring contents from the
bowl.
Keep hands and utensils out of the processor bowl and liquidiser
jug whilst connected to the power supply.
Switch off and unplug:
before fitting or removing parts
after use
before cleaning
Never use your fingers to push food down the feed tube. Always
use the pusher/s supplied.
Before removing the lid from the bowl or liquidiser/mill from the
power unit:-
switch off;
wait until the attachment/blades have completely stopped;
Be careful not to unscrew the liquidiser jug or mill from the
blade unit.
Allow all liquids to cool to room temperature before placing them
in the liquidiser.
Only operate the liquidiser with the lid in place.
This machine will be damaged and may cause injury
if the interlock mechanism is subjected to excessive
force.
Do not use the lid to operate the processor, always use the
on/off speed control.
This machine is not intended for use by young children or infirm
persons without supervision.
Never use an unauthorised attachment.
Don’t let children play with this machine.
Never leave the machine on unattended.
Never use a damaged machine. Get it checked or repaired: see
‘service’.
Never let the power unit, cord or plug get wet.
Don’t let excess cord hang over the edge of a table or worktop
or touch hot surfaces.
Never misuse your food processor and only use it for its
intended domestic use.
before plugging in
Make sure your electricity supply is the same as the one shown
on the underside of your machine.
Important – UK only
The wires in the cord are coloured as follows:
Blue = Neutral, Brown = Live.
The appliance must be protected by a 3A approved (BS1362)
fuse.
Note:
For non-rewireable plugs the fuse cover MUST be refitted when
replacing the fuse. If the fuse cover is lost then the plug must not
be used until a replacement can be obtained. The correct fuse
cover is identified by colour and a replacement may be obtained
from your Kenwood Authorised Repairer (see Service).
If a non-rewireable plug is cut off it must be DESTROYED
IMMEDIATELY. An electric shock hazard may arise if an
unwanted non-rewireable plug is inadvertently inserted into a
13A socket outlet.
This appliance complies with European Economic Community
Directive 89/336/EEC.
before using for the first time
1 Remove all packaging including the plastic blade covers from the
knife blade. Take care the blades are very sharp. These
covers should be discarded as they are to protect the blade
during manufacture and transit only.
2 Wash the parts see ‘cleaning’
key
processor
pushers
feed tube
lid
detachable drive shaft
bowl
safety interlock
cord storage (at back)
power unit
speed/pulse control
liquidiser outlet/interlock
liquidiser outlet cover/safety interlock
liquidiser
blade unit
sealing ring
jug
lid
filler cap
additional attachments
Not all of these attachments listed below will be included with
your food processor. Please refer to your content list supplied. To
buy an attachment not included in your pack, contact the dealer
from whom you purchased your appliance.
knife blade
dough tool
twin beater geared whisk
maxi-blend canopy
thick slicing/coarse shredding disc
thin slicing/fine shredding disc
fine (Julienne style) chipper disc
rasping disc
geared citrus press
mill
centrifugal juicer
KENSTORE™ attachments carousel
spatula
recipe book
2
21
22
23
24
25
26
27
28
29
30

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kenwood FP540 Series and is the answer not in the manual?

Kenwood FP540 Series Specifications

General IconGeneral
BrandKenwood
ModelFP540 Series
CategoryBlender
LanguageEnglish

Related product manuals