Why is the remote control unavailable for Kenwood K-501USB?
If the remote control for your Kenwood Stereo System isn't working, try replacing the batteries with new ones. Also, ensure you're using the remote control within the specified controllable distance from the system.
How to stop noise interfering with Kenwood Stereo System reception?
To minimize noise interference with your Kenwood Stereo System's reception, position the outdoor antenna away from roads. Also, switch off any nearby electrical appliances that may be causing interference. Try to place the system away from any TV sets.
How to fix no audio output on Kenwood K-501USB?
If there is no audio output from your Kenwood Stereo System, ensure the cables are properly connected as described in the connections section of the manual. Also, make sure the volume is at an audible level and that muting is off. If you're using headphones, try unplugging them.
What to do if there is no audio from headphones with Kenwood K-501USB Stereo System?
If you're not getting any sound through your headphones on your Kenwood Stereo System, start by checking that the headphone plug is fully and correctly inserted. If it is, increase the volume level to a suitable listening level.
Why is there no audio from one speaker on my Kenwood K-501USB Stereo System?
If you're experiencing audio from only one speaker on your Kenwood Stereo System, check that the speaker cables are properly connected, referring to the connections section in the manual. Also, adjust the balance settings to ensure sound is distributed evenly between the speakers.
Why Kenwood K-501USB Stereo System loaded CD cannot be played back?
If a CD isn't playing on your Kenwood Stereo System, ensure that the CD is placed correctly with the label side facing up. If it still doesn't play, clean the disc as described in the 'Care and storage of CD' section. If condensation is present, follow the instructions in 'Be careful against condensation' to evaporate it.
What to do if Kenwood K-501USB Stereo System displays [LOCKED] and the disc won't eject?
If your Kenwood Stereo System displays [LOCKED] and the disc won't eject, unplug the power cord from the outlet. While holding the eject key, plug the power cord back in.
Why does recording stop in the middle on Kenwood Stereo System?
If recording stops unexpectedly on your Kenwood Stereo System, it could be because the memory card is full. Erase any unnecessary music files to free up space. Alternatively, use a memory card that has available space for recording.
What to do if after Auto Memory no station can be received by pressing the P.CALL key on Kenwood Stereo System?
If, after performing Auto Memory on your Kenwood Stereo System, no station can be received when pressing the P.CALL key, try performing Auto Memory again. If the issue persists, manually preset stations with receivable frequencies.
How to activate timer on Kenwood Stereo System?
To activate the timer on your Kenwood Stereo System, first, set the correct time by following the instructions in “Adjusting the Time of Day”. Then, set both the timer start time and the end time.
General| USB Playback | Yes |
|---|---|
| Power Output | 50 W |
| Bluetooth | No |
| CD Player | Yes |
| Speakers Included | Yes |
| Remote Control | Yes |
| RMS output power | 25 W |
| Playback media | CD |
To Next Page
