Need help?Do you have a question about the Kenwood KAC-801 and is the answer not in the manual?
Select a stable installation position for the amplifier, considering easy access and driving safety.
Mount the amplifier unit directly onto the car's chassis or frame using the four supplied screws.
Place the bracket under the floor mat and secure the unit with supplied screws, washers, and nuts.
Fix the bracket to the chassis or frame, then attach the unit to the bracket using supplied hardware.
Connect the amplifier's power lead to the ignition-switched +12V line and the ground lead to the chassis.
Connect input cables from other audio components to the amplifier's DIN connector, ensuring proper alignment and release.
Connect the amplifier's output leads (marked 'RIGHT' and 'LEFT') to the respective speaker terminals.
Replace a blown fuse following the indicated procedure to restore power to the system.
If amplifier issues occur, turn off the system and contact your KENWOOD dealer before resuming operation.
Periodically remove dust from the amplifier's surface, which acts as a heat sink, to prevent thermal overload.
To Next Page
General
