Need help?Do you have a question about the Kenwood KAC-823 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Power Output (Peak) | 300 Watts |
| Impedance | 2-8 Ohms |
| Signal-to-Noise Ratio | 100 dB |
| THD at RMS Power | 0.08% |
| Bridged RMS Power at 4 Ohms | 150 Watts |
| Input Voltage | 14.4V |
Follow instructions to prevent fires and personal injury, including using proper cables and avoiding contact with hot surfaces.
Be aware of short-circuits causing blown fuses and fire hazards. Ensure unconnected wires are insulated.
To prevent fire from wiring shorts, install a fusible link or breaker between the battery and power terminals.
Mount the unit securely using tapping screws, ensuring it does not interfere with driving.
Exercise caution when drilling holes to avoid damaging fuel tanks, brake tubes, or wiring harnesses.
Ensure combined speaker impedance is at least 2 ohms in bridged/monaural mode to avoid amplifier damage.
Ensure the combined speaker system impedance is at least 2 ohms in this configuration to prevent amplifier damage.
If no sound from one side, check speaker cord connections; ensure each terminal connects to its respective output.
Distorted sound may be due to incorrect speaker wiring or pinched speaker cords; check connections and wiring.
To resolve AM beat noise, adjust the 'Beat Canceler' on the unit's bottom using a screwdriver.
To Next Page
