Kenwood NX-5200 User Manual

Function
Menu
Display
PF Key
Menu
Analog
Conv.
NXDN
Conv.
P25
Conv.
NXDN
Trunking
P25
Trunking
Talkgroup Reset Talkgroup Rst
p p
N/A N/A
p
N/A N/A
Transceiver Password Password
p p p p p p p
TX Audio Equalizer (High) TX EQ High N/A
p
N/A
p p p p
TX Audio Equalizer (High
Midrange)
TX EQ High
Mid
N/A
p
N/A
p p p p
TX Audio Equalizer
(Midrange)
TX EQ
Midrange
N/A
p
N/A
p p p p
TX Audio Equalizer (Low
Midrange)
TX EQ Low
Mid
N/A
p
N/A
p p p p
TX Audio Equalizer (Low) TX EQ Low N/A
p
N/A
p p p p
TX Auto Gain Control TX AGC N/A
p
N/A
p p p p
Vibrator Vibrator
p p p p p p p
Zeroize Zeroize
p p p p p p p
Zone Down -
p
N/A
p p p p p
Zone Select *5 -
p
N/A
p p p p p
Zone Up -
p
N/A
p p p p p
*1
Channel Select can be programmed only on the Selector knob.
*2
Emergency can be programmed only on the Auxiliary (orange) key and the optional speaker/
microphone PF 1 (orange) key.
*3
In P25 Conventional systems, Group + Short Message and Group + Status functions in the same
manner as Group. Sending of short messages and status messages is not supported.
*4
Keyset and Rekey Request can be used when set as P25 OTAR.
*5
Zone Select can be programmed only on the Selector knob and the Lever switch.
18

Kenwood NX-5200 Specifications

General

IP Rating	IP67
Zones	128
GPS	Yes
Bluetooth	Yes
Voltage Range	7.5V DC ±20%
Operating Temperature	-30°C to +60°C
Frequency Range	136-174 MHz
Battery Life	14 hours (Digital mode)
Digital Protocol	NXDN, DMR
Display	LCD