2
Enter a character using the [J] and [K] keys.
●
On full key model transceivers, you can enter the password directly by pressing the
keypad.
Refer to “CHARACTER ENTRY” {p. 19} .
3
Press the [ ] or [ ] key to accept the character.
4
Repeat steps 1 and 2 to enter the entire password.
●
Press the [
] or [#] key to delete an incorrectly entered character. Press and hold the
[
] or [#] key to delete all characters.
5
Press the [
] or [ ] key to confirm the entry.
●
If you enter an incorrect password, an error tone sounds and the transceiver remains
locked.
●
The password can contain a maximum of 6 digits.
SELECTING A ZONE AND CHANNEL
1
Select the desired zone using the keys programmed as [Zone Up]/ [Zone
Down]. Each zone contains a group of channels.
2
Select the desired channel using the keys programmed as [Channel Up]/
[Channel Down]. Each channel is programmed with settings for transmitting and
receiving.
●
The transceiver may have names programmed for zones and channels. The zone
name and channel name can contain up to 16 and 14 characters respectively.
4