2
Press the [J] and [K] keys to select a unit ID from the list that has been pre-
entered into your transceiver.
Alternatively, on full key models, you can enter a unit ID directly by pressing the keypad.
●
Press the [ ] key to enter the manual input mode.
To delete the code entered, press the [ ] key to delete one digit, or press and hold
the [ ] key to delete all digits.
3
Press and hold the PTT switch to make the call.
●
“Individual” and the ID name of the target transceiver are displayed. “Calling” appears
on the display while the call is being made, and disappears once the call is established.
●
Speak into the transceiver as you would during a normal call.
RECEIVING
1
Select the desired zone and channel using the Selector knob and the [Zone
Up]/ [Zone Down] or [Channel Up]/ [Channel Down] keys. (If the Scan function
has been programmed, you can switch it on or off as desired.)
2
When you hear the caller’s voice, readjust the volume as necessary.
●
If signaling has been programmed on the selected channel, you will hear a call only if
the signal tone matches the tone set up on your transceiver.
Note:
●
Signaling allows your transceiver to code your calls. This will prevent you from listening
to unwanted calls. It does not make calls private, it only prevents them from being heard
by transceivers set with a different signaling code. Refer to “SIGNALING” {p. 47} for
details.
●
A ringing tone will sound when receiving a call if the alert tone has been enabled in the
Alert Tone setting. For details, consult your dealer.
12
To Next Page
Loading...
Need help?
General
