What to do if Kenwood Transceiver buttons and selector do not function?
If the buttons and selector on your Kenwood Transceiver are not working, the Button Lock may be activated. Try pressing or holding the button programmed as [Button Lock] to deactivate it. Alternatively, Super Lock may be activated. To deactivate Super Lock, turn OFF the transceiver, then press and hold the PTT switch and Side 2 button while turning ON the transceiver.
How to fix Kenwood Transceiver that cannot turn on?
If your Kenwood Transceiver will not turn on, the battery pack may be dead. Try recharging or replacing the battery pack. Alternatively, the battery pack may not be installed correctly. Remove the battery pack and reinstall it.
What to do if I cannot talk to or hear other members in my Kenwood ProTalk NX-P1300AU group?
If you cannot communicate with other members in your Kenwood Transceiver group, ensure you are using the same frequency, QT/DQT, or RAN settings. Also, verify if other group members are using Scrambler/Encryption; if so, turn on your transceiver’s Scrambler/Encryption. When using the Reserved Group function, confirm that your Reserved Group ID matches the other group members'.
Why does my Kenwood Transceiver battery power die shortly after charging?
If your Kenwood Transceiver battery dies quickly after being charged, it likely means the battery pack's lifespan is over and needs replacing.
What to do if I hear other voices (besides group members) on the channel of my Kenwood ProTalk NX-P1300AU Transceiver?
If you are hearing voices other than your group members on the channel of your Kenwood Transceiver, change the QT/DQT or RAN settings. Make sure all group members also change their transceiver settings to match the new QT/DQT or RAN settings.
General| Brand | Kenwood |
|---|---|
| Model | ProTalk NX-P1300AU |
| Category | Transceiver |
| Language | English |
Identifies and describes the transceiver's main controls: Selector, LED, Power, PTT, and Side buttons.
Steps to power on, adjust volume, and switch between zones and channels.
Procedure for transmitting voice using the PTT switch.
Outlines programming patterns and diagrams for different transceiver models.
Steps for configuring NXDN ID, Reserved Group ID, and selecting zones.
Guide for programming channel parameters like frequency and type.
Guide to setting the unique NXDN identification code for the transceiver.
Procedure for configuring the Reserved Group ID for group calls.
Configuring VOX for hands-free transmission and setting gain levels.
To Next Page