Need help?Do you have a question about the Kenwood R-5000 and is the answer not in the manual?
General| Modes | AM, FM, SSB, CW |
|---|---|
| Impedance | 50 ohms |
| Frequency stability | ±100 Hz |
| Memory Channels | 100 |
| Sensitivity | 0.5 μV (SSB) |
| Selectivity | 6 kHz (AM) |
| Power Supply | 13.8 V DC |
| Image rejection | 70 dB |
| IF rejection | 80 dB |
| Output | 1.5W at 8 ohms |
Explains the noise blanking circuit and its operation.
Details the phase-locked loop circuitry for frequency synthesis.
Details the µPD78009G microcontroller, its block diagram, and functions.
Provides data for the M5M82C55AP-5 interface chip, including block diagram and functions.
Lists components and their functions in the RF unit.
Describes components and their operations within the IF unit.
Lists components and their functions in the PLL unit.
Details components and their functions within the control unit.
Lists the essential test equipment for performing adjustments.
Details the step-by-step adjustment procedures for PLL circuits.
Covers adjustments for various other circuits, including reset and voltage checks.
Details the technical specifications for the VC-20 VHF converter.
Specifies the receiver's operational frequency coverage.
Details the receiver's sensitivity performance across different modes.
To Next Page
