Kenwood R-SE9 User Manual

PRECAUTIONS FOR REPAIR
• For the SERIAL TEST CODE LIST of the circuit description, see Service manual (B51-5210-00) of R-SA7.
• For the INITIAL STATE, the BACK UP and the MICROPROCESSOR of the circuit description, see Service manual (B51-
5373-00) of R-SE7.
• No connection of ground line if disassemble the unit.
• Please connection the ground line on rear panel, PCBs, Chassis and some others.
STEREO INTEGRATED AMPLIFIER/TUNER
R-SE9
SERVICE MANUAL
©1997-10/B51-5375-00 (K/K) 888
band
volume control
auto/mono enter
phones
mode
pure
multi control
N.B.
∞ ∞
down up
stereo integrated amplifier/tuner R-SE9
A
TRAITR
on/standby
SYSTEM
CONTROL
ANTENNA
AM
GND
FM75
CD
IN IN
REC PLAY
SUPER
WOOFER
PRE OUT
SPEAKERS
( 6 - 16 )
L
R
TAPE
REC PLAY
MD
AUX
R
L
Side plate
(A50-1303-02)
Panel*
(A60-)
Front glass
(B10-2369-03)
AC power cord *
(E30-)
Screw terminal board
(E70-0061-05)
Lock terminal board
(E20-0476-05)
Phono jack
(E63-1014-05)
Phono jack
(E63-0046-15)
Phono jack
(E63-0047-15)
Rectangular receptacle
(E08-0312-05)
Metallic cabinet
(A01-3463-11)
Power cord bushing
(J42-0083-05)
Knob
(K29-6741-04)
Knob
(K29-6738-04)
Knob
(K29-6739-04)
Knob
(K29-6751-04)
(HM-901)
* Refer to parts list on page 21.
R-SE9(K) 1P 97.11.29 3:34 AM y[W 2

Kenwood R-SE9 Specifications

General

Type	Stereo Receiver
Power Output	25 watts per channel into 6Ω (stereo)
Frequency Response	10 Hz - 100 kHz
Total harmonic distortion	0.05%
Input Sensitivity	150 mV (line)
Signal-to-Noise Ratio	85dB (line)
Dimensions	205 x 116 x 310mm
Weight	6.5 kg
Speaker Impedance	6Ω to 16Ω
Speaker load impedance	4 - 16 ohms

Summary

R-SE9 Service Manual Overview

Service Precautions for R-SE9

Important safety warnings and guidelines for servicing the unit.

R-SE9 Circuit Description

Tuner Destination List

Details destination-specific tuner configurations and settings.

Test Mode Overview

Procedures for entering, canceling, and operating test modes.

AMP Test Mode Operations

Describes entering, canceling, and contents of the AMP test mode.

RDS Test Mode Operations

Procedure to enter, cancel, and contents of the RDS test mode.

Serial Test Mode Procedures

Instructions for entering, canceling, and cautions for the serial test mode.

R-SE9 Adjustment Procedures

FM Section Adjustment

Adjustment procedures and settings for the FM tuner section.

Audio Section Adjustment

Adjustment procedures and settings for the audio amplifier section.

System Connections for Adjustment

Diagrams showing system connections for adjustments.

Exploded View of R-SE9 Unit

R-SE9 Parts List

Main Unit Parts List

List of parts for the R-SE9 main unit.

Tuner Unit (Model M) Parts List

List of parts for the R-SE9 Tuner Unit (Model M).

Tuner Unit (Model T) Parts List

List of parts for the R-SE9 Tuner Unit (Model T).

Display Unit Parts List

List of parts for the R-SE9 Display Unit.

R-SE9 Technical Specifications

Amplifier Specifications

Technical specifications for the amplifier section of the R-SE9.

FM Tuner Specifications

Technical specifications for the FM tuner section of the R-SE9.

AM Tuner Specifications

Technical specifications for the AM tuner section of the R-SE9.

General Unit Specifications

General specifications including power consumption, dimensions, and weight.