11
RECEIVING
Your dealer may have programmed QT, DQT, or 2-Tone
signaling for the channel that you select. If so
programmed, you will hear transmissions from other
transceivers IN YOUR SYSTEM ONLY! Otherwise, you
will hear ALL TRANSMISSIONS made by ANY stations
using the same channel.
1 Switch ON the transceiver by turning the POWER/VOL
control clockwise.
• A “click” is heard. A beep also sounds if so
programmed by your dealer.
To switch OFF the transceiver, turn the POWER/VOL
control counterclockwise until a click is heard.
2 To adjust the volume, turn the POWER/VOL control
while using [MONI] to listen to channel background
noise.
• While communicating with other parties, you may
need to adjust the volume more precisely.
3 Use the CHANNEL selector to choose your regular
operating channel.
• Turning the selector clockwise increases the
channel number and turning the selector
counterclockwise decreases the channel number.
• Non-programmed channels cannot be used.
Selecting a channel that is unprogrammed
generates an Alert beep.
To Next Page
Loading...
Need help?
General
