Kenwood TK-3202L User Manual

Document Copyrights
Copyright 2006 by Kenwood Corporation. All rights reserved.
No part of this manual may be reproduced, translated, distributed, or transmitted in any
form or by any means, electronic, mechanical, photocopying, recording, or otherwise, for
any purpose without the prior written permission of Kenwood.
Disclaimer
While every precaution has been taken in the preparation of this manual, Kenwood
assumes no responsibility for errors or omissions. Neither is any liability assumed for
damages resulting from the use of the information contained herein. Kenwood reserves
the right to make changes to any products herein at any time for improvement purposes.

Kenwood TK-3202L Specifications

General

frequency range	450~490MHz (K, M) 470~512MHz (K2, M2) 400~430MHz (K3)
number of channels	Max. 16
channel spacing	25kHz (Wide) 12.5kHz (Narrow)
PLL channel stepping	5kHz, 6.25kHz
operating voltage	7.5 V DC ±20%
frequency stability	±2.5ppm (–30˚C to +60˚C)
channel frequency spread	40MHz (K, M) 42MHz (K2, M2) 30MHz (K3)

Operating Environment

operating temperature range	–30˚C to +60˚C
battery life with KNB-45L	Approx. 18 hours

Receiver

sensitivity EIA 12dB SINAD	0.25µV (Wide)/0.28µV (Narrow)
selectivity	70dB (Wide)/60dB (Narrow)
intermodulation	65dB (Wide)/60dB (Narrow)
spurious response	60dB
audio power output	500mW at 8 Ω less than 10% distortion

Transmitter

RF power output	4W/1W
spurious and harmonics	65dB
modulation	16K0F3E (Wide)/11K0F3E (Narrow)
FM noise	45dB (Wide)/40dB (Narrow)
audio distortion	Less than 5%

Weight and Dimensions

dimensions (radio only)	54 W x 122 H x 21.1 D mm
weight (radio only)	160g
dimensions with battery	54 W x 122 H x 33 D mm
weight with battery	280g

Summary

Realignment Procedures

PC Mode Operation

Circuit Description

Parts List

Adjustment Procedures

Required Test Equipment

Adjustment Points and Frequency/Signaling

Details specific adjustment points and frequency/signaling settings.

Common Section Adjustments

Details common adjustments like setting, VCO lock voltage.

Transmitter Section Adjustments

Outlines adjustments for transmitter performance.

Receiver Section Adjustments

Details adjustments for receiver performance.

Sensitivity and Squelch Adjustments

Schematic Diagrams

Block Diagrams

Specifications

General Specifications

Covers frequency range, channels, and general parameters.

Receiver Specifications

Details receiver performance metrics like sensitivity and selectivity.

Transmitter Specifications

Details transmitter performance metrics like power output and modulation.