To Next PageTo Next Page
Need help?Do you have a question about the Kenwood TK-760G series and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | TK-760G series |
| Category | Transceiver |
| Language | English |
Lists the specific transceiver models included in this manual.
Government law prohibitions, illegal operation penalties, and service referral guidelines.
Hazards related to explosive atmospheres, RF transmissions, and dynamite blasting caps.
Precautions to prevent fire, injury, and damage, including driving safety and environmental factors.
Lists all items included in the transceiver package, with part numbers and quantities.
Lists the necessary tools for installing the transceiver, including drill bit sizes.
Instructions for connecting the DC power cable to the vehicle's battery.
Identifies and describes the front panel controls and microphone functions.
Explains the meaning of various icons and indicators shown on the transceiver display.
Details the connectors and ports located on the rear of the transceiver.
Identifies and describes the front panel controls and microphone functions.
Explains the meaning of various icons and indicators shown on the transceiver display.
Details the connectors and ports located on the rear of the transceiver.
Instructions for powering the transceiver on and off, including password protection.
How to increase or decrease the audio volume using designated keys.
Procedure for choosing a specific channel or group for communication.
Steps to initiate a transmission and speak into the microphone.
How the transceiver handles incoming calls based on signaling features like QT/DQT.
How to monitor multiple channels and stop on a signal.
How the transceiver monitors a priority channel while scanning others.
Methods to exclude channels from scan and select a revert channel.
Procedures for making calls using DTMF tones via the keypad.
How to save DTMF numbers into memory locations for quick access.
How to retrieve and use saved DTMF numbers.
Procedures for deleting stored numbers and redialing the last transmission.
How the transceiver behaves when receiving signals with correct codes.
Steps for initiating a transmission using Code Squelch.
How the transceiver receives calls based on ID, Intermediate, and message codes.
How the transceiver handles incoming signals with correct 2-tone sequences.
Steps for encoding and transmitting 2-tone signals.
Features to limit transmission duration and prevent interference on busy channels.
Functions for direct communication and external call notification.
How to listen to weak signals or adjust volume without a signal present.
Signals sent at beginning/end of transmission for repeater access.
Using the PA system and activating the auxiliary port.
