Need help?Do you have a question about the Kenwood TK-760G and is the answer not in the manual?
General| Brand | Kenwood |
|---|---|
| Model | TK-760G |
| Category | Transceiver |
| Language | English |
Recommended precautions for safe operation of equipment.
Information for servicing the radio using manual diagrams.
Steps from merchandise received to delivery.
List of functions that can be programmed to keys.
Summary of the transceiver's programmable features.
Functions programmable via FPU, including AUX.
Procedure to enter emergency mode and system charts.
Enabling the external horn alert function.
Activating the public address system via microphone.
Details on scan types and start/stop conditions.
Details on Time-out timer, PTT ID, and password.
Setting a limit for continuous transmission.
Sending DTMF ANI with PTT press.
Generating a tone before Time-Out Timer expires.
Time limit before re-transmission after TOT.
Minimum wait time to reset the TOT count.
Configuration of DTMF and 2-Tone signalling options.
Selecting AND or OR for signalling match logic.
Inhibits transmission if a specific code is matched.
Description of various tones indicating transceiver states.
Tone indicating impending TOT expiry.
Procedures for entering each mode via power-on combinations.
Setting method for Panel Test Mode.
Preface, connection, and programming steps for firmware updates.
Procedure for transferring data between radios.
Writing frequency and signalling data via panel.
Setting up each channel using panel keys.
Setting up channels and functions using panel keys.
Clearing all settings to default values.
Installation of the KCT-19 accessory connection cable.
Installation and connection of the KCT-18 ignition sense cable.
Installing the KAP-1 unit for PA and Horn Alert functions.
Procedures for enabling emergency mode.
Description of the PLL circuit for frequency generation.
General outline of the transmitter circuit.
Description of the power amplifier stages and filters.
Description of the Automatic Power Control circuit.
Description of CPU control over various functions.
Description of the PA switch operation.
Description of the power supply and overvoltage protection.
Visual guide to the assembly of the TK-760G transceiver.
Visual guide to the assembly of the TK-762G transceiver.
Features and controls available in TK-760G test mode.
Equipment and setup required before tuning the transceiver.
Procedure to place the transceiver into tuning mode.
Various parameters adjustable in tuning mode.
List of test equipment required for alignment.
Procedure for adjusting PLL lock voltage.
Receiver adjustments including Discriminator and Sensitivity.
Procedure for adjusting the discriminator.
Procedure for adjusting receiver sensitivity.
Procedure for adjusting Squelch 3.
Procedure for adjusting Squelch 9.
Transmitter adjustments including Frequency, Power, and High Power.
Procedure for adjusting the transceiver frequency.
Procedure for adjusting RF power output.
Procedure for adjusting high power output.
Procedure for adjusting low power output.
Procedure for checking transceiver power output.
Procedure for adjusting modulation balance.
Procedure for adjusting maximum deviation.
Procedure for checking microphone sensitivity.
Procedure for adjusting QT deviation.
Procedure for adjusting DQT deviation.
Procedure for adjusting DTMF deviation.
Procedure for adjusting TONE deviation.
Electrical schematic diagram for TK-760G/(N) transceiver.
Electrical schematic diagram for TK-762G/(N) transceiver.
To Next Page
