Need help?Do you have a question about the Kenwood TM-631A and is the answer not in the manual?
General| Mode | FM |
|---|---|
| Receiver System | Double conversion superheterodyne |
| Voltage | 13.8V DC ±15% |
| Type | Mobile |
| Dimensions | 140 x 40 x 170 mm |
| Sensitivity | 0.16 μV (12 dB SINAD) |
| Channel Step | 5, 10, 12.5, 15, 20, 25 kHz |
Detailed technical specifications for the TM-631A, TM-731A, and TM-731E models.
List of accessories included in the box and optional items with part numbers.
Instructions for installing the transceiver using the mounting bracket.
Diagrams and cautions for connecting the transceiver in a vehicle.
Identification and description of each control on the transceiver's front panel.
Initial setup for receiving signals, dual band, and single band reception.
Procedures for transmitting, power levels, microphone usage, and duplex transmission.
Selecting transmit offsets and using the reverse function for repeater communication.
Using sub-audible tones and CTCSS for repeater access and tone squelch.
Information on the lithium battery and resetting the microprocessor to factory defaults.
Overview of memory channels and what data can be stored in them.
Description of scan types and how to program programmable band scans.
Explanation of Time Operate scan and Carrier Operated scan modes.
Procedure for scanning through stored memory channels.
How to perform simultaneous scanning on both bands.
How to monitor a specific channel at intervals while operating on another.
How to temporarily skip unwanted memory channels during scans.
Factory alignment, warranty, and procedures for returning equipment for repair.
How to clean the transceiver's knobs, front panel, and cabinet.
Step-by-step guide for installing the optional CTCSS unit.
Introduction to the RC-10 remote controller and its basic functions.
To Next Page
