What to do if scan doesn't work on Kenwood Transceiver?
If the scan function isn't working on your Kenwood Transceiver, it might be due to an incorrectly set squelch. Try adjusting the SQL control to the point where background noise is just eliminated.
Why UP/DOWN buttons or Tuning control does not change the frequency on Kenwood Transceiver?
If the UP/DOWN buttons or the Tuning control aren't changing the frequency on your Kenwood Transceiver, the Frequency Lock function may be enabled. Press the F.LOCK button to disable it.
What to do if memory scan doesn't work on Kenwood TS-50S?
If the memory scan isn't working on your Kenwood Transceiver, consider these potential causes: * Ensure that you have stored data in at least two memory channels. * Verify that the memory channels you want to scan are not locked out; unlock them if necessary. * If you're using Group Scan, confirm that the channel you want to scan is within the current group, or select All-channel Scan.
What to do if Kenwood TS-50S Transceiver power on results in no display data and no sound?
If your Kenwood Transceiver shows no display and produces no sound when powered on, check the following: Ensure the DC power cable plug is fully inserted into the 13.8 V DC connector on the transceiver's rear panel. Also, inspect the fuse and replace it with a new one of the same rating if it's open. Finally, verify that the DC power supply is switched on.
Why received signals cannot be understood or demodulated on Kenwood TS-50S Transceiver?
If you're having trouble understanding or demodulating received signals on your Kenwood Transceiver, here are a few things to check: First, make sure the Receiver Incremental Tuning (RIT) function is activated by pressing the RIT button. Next, ensure the IF SHIFT control is in the center detent position. Lastly, verify that the standard 2.4kHz SSB filter is selected, and not the optional 0.5kHz filter.
General| Brand | Kenwood |
|---|---|
| Model | TS-50S |
| Category | Transceiver |
| Language | English |
To Next Page
