Need help?Do you have a question about the Kenwood TS-950SD and is the answer not in the manual?
General| Type | HF Transceiver |
|---|---|
| Supply Voltage | 13.8 VDC |
| Modes | AM, FM |
| Receiver Sensitivity (SSB/CW) | 0.2 µV |
| Receiver Sensitivity (FM) | 0.5 µV |
| Selectivity (CW) | 500 Hz (-6 dB) |
| Selectivity (AM) | 6 kHz (-6 dB) |
| Selectivity (FM) | 15 kHz (-6 dB) |
| Image Rejection | 70 dB |
Details the frequency configuration for SSB, CW, and FM modes, and explains dual conversion.
Explains the PLL circuit, which generates local oscillator signals for frequency synthesis.
Explains the transmitter system configuration and signal paths.
Lists components and their functions for the Switch Unit (A).
Lists components and their functions for the RF Unit.
Lists components and functions for the Digital Unit.
Provides precautions and notes regarding the parts list.
Lists parts for the Switch Unit (A).
Illustrates the disassembly steps for the TS-950S, part 1 of 6.
Continues disassembly illustration for the TS-950S, part 2 of 6.
Lists required test equipment for adjustments, including multimeters and oscilloscopes.
Details adjustment procedures for various receiver sections.
Defines terminal functions for Switch Unit (A).
Defines terminal functions for the AVR Unit.
Details the level diagram for the receiver section.
Illustrates the level diagram for the transmitter section.
Shows the component side view of Switch Unit (A).
Shows the component side view of the RF Unit.
Schematic diagram of the MIC input high-pass filter.
Schematic diagram of the limiting amplifier circuit.
Provides the detailed specifications for the TS-950S/SD transceiver.
Contains important notes regarding specifications and changes.
To Next Page
