In
case
of
difficulty
Certain inputs cannot
be
selected using
the
remote
control.
Remote
control operation
is
not
possible.
• No setup codes registered for the respective
input(s)
• The remote control
is
set to a different opera-
tion mode.
• Batteries are exhausted
• The remote control unit
is
too far away from
the main system, controlling angle
is
too large,
or there is
an
obstacle
between
the receiver
and the remote
• The audio cords and system control cords are
not connected properly
• No software
is
loaded
in
the source compo-
nent
•
An
attempt
is made to
playa
tape which
is
being recorded
in
the cassette deck.
• The remote control has not been set to the
operation mode
for
the component you Wish
to control
• Registera setup code at the respective input(s).
-mJ-mJ
• Press the source select keys or SOURCE
(')
keys to select the appropriate operation mode.
• Replace
with
new
batteries.
• Operate the remote control unit within the
controllable range.
• Connect properly referring to "Setting up the
system"
• Place software in the source component you
want
to play.
•
Wait
until recording has completed.
• Press the source select keys or SOURCE
(')
key to activate the operation mode
for
the
component
you
want
to
control
before
operation
-CSl
To Next Page
Loading...
Need help?
General
