Kerlink Wirnet iFemtoCell-evolution 923 - Installation of Wirnet iFemtoCell-evolution; Mounting the Enclosure

5. Markings
Symbol Descripon Symbol Descripon
Wirnet iFemtoCell-evoluon Type of equipment QR Code
12V 0,5mA
Power supply informaon
or other marking
CE marking indicang that the product
complies with current European
direcves or other marking marking
depending on the country
Board ID Serial number of board
Marking indicang that the product
complies with RoHS direcves
Final product ID Serial number of product Do not dispose of with domesc waste
MAC ADDR MAC address
Product must be installed on a non-
ammable substrate (UL94V0). Refer to
the installaon instrucons
Refer to the installaon instrucons
before powering up
EUI Extended Unique Idener
IP 30 Indice of protecon
6. Installaon of Wirnet™ iFemtoCell-evoluon
6.1 Mounng of the enclosure
• The Wirnet™ iFemtoCell-evoluon enclosure must be
mounted on any concrete pedestal, concrete wall or any
non-ammable surface (UL94-V0).
• It must not be mounted on a ammable surface.
The Wirnet™ iFemtoCell-evoluon may be mounted on a wall using
the two oblong holes.
Only two screws (not included) are needed, all mounng informaon
is menoned on the following drawing.
V3.0 | 01.06.2020 |Page 4