60 TALJG_A/TALSG_A/TPLJG_A/TPLSG_A-BA-e-2011
The determined average weight of an individual part will be assumed as the
reference weight immediately after the weighing result is stabilized.
The following will be displayed: the currently placed “G” weight, reference weight
“AUW” and the number of pieces “St.”.
Remove the reference load. The scale is in the counting mode and counts all
parts present on the scales plate.
If it is impossible to create the reference value due to the weighed
material instability or insufficient reference load, the following will be
displayed in the course of determining the reference value:
Exceeding the minimum weight of the counted pieces
Increase the weight of the counted pieces or choose a scale with
greater interval.
The scale request “Consecutive part...” will be displayed to optimize the
reference weight as the placed number of pieces is not sufficient to
ensure correct determination of the reference value.
Place consecutive parts in at least double amount.
Press the PRINT button, the reference value is calculated again.
If the placed number of pieces is
still too low, add other parts (double
amount) and confirm by pressing
the PRINT button. Repeat the
process until the number of pieces
is displayed.
The placed number of pieces is
sufficient to create the reference
value. Remove the reference load.
The scale is in the counting mode
and counts all parts present on the
scale plate.
To Next Page
Loading...
Need help?
General
