CM-BA-e-0618
9
7 Operation
7.1 Overview of display CM 60-2N / CM 150-1N / CM 320-1N / CM 1K1N
(Units on display)
7.2 Overview of display CM 50-C2N
(Units on panel sheet)
7.3 Overview of display CM 500-GN1
(Units on panel sheet)
7.4 Operating elements
7.4.1 Weighing
Switch the balance on by pressing the
key.
The balance will show “8888” for approx. 3 seconds and then change to “0”. Now it
is ready for use.
Important: If the display does not show 0, press the key.
Only now (!) place object on the weighing pan. Make sure that the weighing object
does not stripe or touch the housing or base.
If the object should be heavier than the weighing range allowance, the symbol “E”
(overload) will appear on the display .
To Next Page
Loading...
Need help?
General
