DE-BA-defsi-0640
53
7 Operation
7.1 Overview of display
7.2 Weighing
Switch on the balance using the key
The balance shows for approx. 3 seconds „88888“ in the display and then goes to
„0“. Now it is ready for operation.
Important: Should the display flash or not be on „0“, press the
key.
Only now (!) place goods onto weighing plate. Take care that the weighed material
does not touch the balance housing or the base mat.
Now the weight is displayed, after the standstill control appears the weighing unit
(e.g. g or kg) right-hand in the display.
If the goods are heavier than the weighing range, the display will show "Error"
(=Overload), and a whistle is sounded.
To Next Page
Loading...
Need help?
General
