Need help?Do you have a question about the KERN 572 and is the answer not in the manual?
General| Weighing capacity | 600 g |
|---|---|
| Calibration | External |
| Display | LCD |
| Category | Scales |
| Material | Stainless steel |
| Weighing units | g, oz, ozt, dwt, ct, gn, tl |
| Power supply | AC Adapter |
Explains the intended purpose and correct way to use the balance for accurate weighing.
Emphasizes the importance of carefully reading the operation manual before setup and use.
States that only trained staff are permitted to operate and maintain the appliance.
Provides instructions and important safety notes for connecting the balance to the mains power supply.
Explains the importance and process of adjusting the balance for accurate weighing based on location.
Step-by-step guide for performing external calibration using a specific, pre-defined adjustment weight.
Instructions for external calibration when using a user-specified adjustment weight.
Provides clear instructions for powering the balance on and off safely.
A step-by-step guide for performing a basic weighing operation.
Explains how to reset the balance to zero before starting a weighing.
Details the process of taring to measure the net weight of goods.
Addresses issues where the balance display is not illuminated, listing possible causes.
Explains causes for an unstable or fluctuating weight reading on the display.
Lists common reasons for inaccurate weighing results and potential solutions.
Explanation for the "Zero setting range exceeded" error message.
Explanation for the "Zero setting range not achieved" error.
Explanation for the "Load unstable" error message.
Explanation for the "Adjustment error" message.
Explanation for the "Underload" error message.
Explanation for the "Overload" error message.
Explanation for the error indicating depleted battery capacity.
To Next Page
