be shown.
Select desired setting (no, ok, ng) by .
Confirm input by .
Press ; weighing system is in tolerance weighing
mode. From here evaluation takes place whether the load
is within the two tolerance limits.
Weighing with tolerance range:
Determine the item weight, see chap. 7.11
Tare when using a weighing container.
Put on goods to be weighed, tolerance control is started.
The symbols show whether the load is
within the two tolerance limits.
Load below specified
tolerance
Load within specified
tolerance
Load exceeds specified
tolerance
• The tolerance control is not active when the weight is under 20d.
• To delete limits, enter „00000 PCS“.
To Next Page
Loading...
Need help?
General
