FKB-BA-e-2010 27
The balance will calculate the average item weight and then displays the quantity of
pieces.
Remove reference weight. The balance is now in parts counting mode counting all
units on the weighing pan.
2. Parts counting
Put the empty container on the weighing pan and press the TARE button. The
container is tared, the zero display will appear.
Fill the counting quantity. The piece quantity is shown in the display.
With the - key you can switch between number of items and weight
display
11.2.2 Check counting
The balance allows weighing of goods until a certain target quantity is reached within
defined tolerance limits. With this function one can also check if the weighing good is
within a defined tolerance range.
Reaching the target value is indicated by an acoustic (if activated in menu) and an optic
signal (tolerance mark , , ).
Optical signal:
The tolerance marks provide the following information:
Target quantity exceeds defined tolerance
Target quantity within defined tolerance
Target quantity below defined tolerance
Audio signal:
The acoustic signal depends on the menu setting
< setup beeper >, see chap. 13.3.1.
To Next Page
Loading...
Need help?
General
