PBS/PBJ-BA-e-1718 14
3.1.2 Setting the decimal point when entering numerical values
Entering a decimal point is necessary only for determining the specific gravity or if a
multiplier shall be defined for the user-defined unit.
• Repeat actuating the button until the last digit flashes. Actuate the
button again in order to call up the decimal point setting mode. The reversed
triangle symbol ▼or the current decimal point flashes.
• Actuate the button in order to move the decimal point to the required
position by one digit each.
• Actuate the button to define the position of the decimal point. The
message „SEt“ which appears for a short period of time indicates that setting
has been completed.
To Next Page
Loading...
Need help?
General
