Kernel KN-5000C - Page 82

73
5
Shows "The lamp is
not lighted up or the
lamp is off during
irradiation”.
The cables of the
handle are not
connected
Reconnect the cables of the
handle after shutting down
the equipment
The button of the
handle is
breakdown
Please contact the
manufacturer.
Lamp breakdown
Please contact the
manufacturer.
6
Shows "The lamp is
not turned off
normally or the lamp is
lighted up when the
irradiation is not
started".
Software failures
Shut down and restart
The cables of the
handle are not
connected
Reconnect the cables of the
handle after shutting down
the equipment
Equipment or
handle failure
Please contact the
manufacturer.
7
Shows "Abnormal
overheating inside the
fixture".
The temperature
inside the lamp is
too high.
Shut down and cool down for
a while before reusing.