KERR KD Gemini - 9.0 General Specifications

KD GEMINI – INSTALLATION/OPERATION MANUAL
KD Gemini May-06
12
9.0 GENERAL SPECIFICATIONS
CLEARANCE TO COMBUSTIBLES
Top 1” (25 mm)
Front 24” (610 mm)
Rear - Access 24” (610 mm)
Side - Non-Access 6” (152 mm)
Side - Access 24” (610 mm)
Flue Pipe 9” (229 mm)
Floor Non-combustible
DRAFT PRESSURE
Breech draft pressure -0.04” wc
Overfire draft pressure -0.01 to 0.02” wc
(Not Applicable to Direct Vent Units)
BURNER INSERTION (overall)
Riello 40F3 & BF3 - Beckett PA402 & 404 2 1/2” (63 mm)
AIR/BLOWER DATA
External static - Non - AC 0.2” wc
External static - AC 0.5” wc
Cooling Air Flow 3 tons
Maximum air temperature rise 85°F
Fan Control 130°F ON, 100°F OFF
High Limit, max design outlet temp 200°F
1/3 hp #1 speed @ 0.50 static 1300 CFM
MOTOR/BLOWER
All Models - 1/3 hp 4 speed/GT 10 DD
FAN/HIGH LIMIT CONTROL
Honeywell L6064A1003 11” or equal
FAN CENTRE RELAY – AC models only
Honeywell R8405A1001/B1009, R8239A1003 or equivalent
DIMENSIONS
Overall Depth 50 5/8” (1286 mm)
Depth 46 3/4” (1187 mm)
Height 44 1/2” (1130 mm)
Width 22 1/8” (562 mm)
PLENUM DIMENSIONS
Cold air return 19 x 20 1/2” (483 x 521 mm)
Hot air supply 23 3/4 x 20 1/2” (603 x 521 mm)
Plenum spacing 1 3/8” (35 mm)
AC COIL LOCATION
Minimum height above the heat exchanger 4” (100 mm)