KETRON SolTon PROGRAMMER 24S - Page 12

51 Press SUING опопшо оп ше оециепсе зесиоп.
4) Press апу voice on the Organ and Strings sections. Such Organ or Strings voices must be necessa-
rily On on each Chord Sequence programming.
5) Press Bass and Piano (if they have been programmed in the Pattern) and choose one of the 4
Bass effects.
6) Press Arranger A or B (if Preset Rhythm has been programmed and if Arranger is desired).
Note that one Song can be formed exclusively with Preset Rhythms and Arranger. In this case
to have a complete background of a Song it is enough to program only the Chord Sequence
(Bass will be automatically programmed with the Arranger).
7) Play on the keyboard, or on the Pedalboard, the first chord of the Song (if you like that the
Song starts with a Chord).
8) Press START. The Song starts playing. From this moment on, any chord or any harmonization
played on the keyboard, or on the Pedalboard, is recorded.
Furthermore any modification apported to the "status" of the various Accompaniment controls
will be immediately recorded. (See PROGRAMMING the STATUS OF the ACCOMPANIMENT).
9) When the Song Chain ends, the Record function goes Off and the Chord Programming stops.
Song returns to the starting position.
If the Song was programmed with a LOOP at the end of the Chain, (See song record) the Chord
Sequence programming stops exactly in the Loop point.
If
the
Chord
Sequence
is
programmed
upon
an
ending
Song
(No
Loop),
when
the
Chord
Sequence
is terminated the Song function stops on Record position.
CAUTION
1) If on the Song are programmed both Pattern Sequencer and Preset Rhythm, the Preset prevails
over the Pattern (that is the Pattern Sequencer follows the chords played on the keyboard).
2) Any Fill In included on a written Song (by Fill In Mode function) must have the same Time
value as the correspondent Pattern of the Song. If this value is different, to press Fill In can
cause problems to the Chord Sequence of the Song.
PROGRAMMING THE STATUS OF THE ACCOMPANIMENT
The Song Chords Sequence function allows also to program the general "Status" of the various
Accompaniment controls.
Before to start playing the Chord Sequence but also whilst the Song plays , it is possible to adjust all
the
Accompaniment
tab
controls
(that
is
Sequencer,
Organ,
Strings,
Bass
and
Arranger)
in
the
desi-
red way and this “status” will be recorded into the Song exactly as selected.
CHORD SEQUENCE PLAYBACK
In
order
to
obtain
the
playback
of
the
programmed
Chord
Sequence
(that
is
the
playback
of
the
entire Song) carry out the following steps:
1) Press SONG and select the required Song number.
CAUTION:
When
Song
Chords
tab
is
On,
The
Program
Change
doesn’t
work.
If
you
push
the
buttons
1-8,
instead
of
Program
Change
you
will
get
the
number
of
the
Fill
In
referred
to
the
same Song (See SONG FILL IN MODE).
In
this
case,
to
select
the
right
Song
number,
it
is
necessary
to
diconnect
first
the
Fill
In
number
and then disconnect Song Chords tab.
2) Press SONG CHORDS.
3) Press START. The complete Song will start playing.
CHORD SEQUENCE CLEAR
In
order
to
Clear
a
complete
Chord
Sequence
follow
these
operations:
1) Press SONG
2) Press SONG twice to reach Clear (Clear lights up)
3) Press SONG CHORDS
4)
Press
FUNCTION.
The
Chord
Sequence
is
now
cancelled.
Song
returns
to
the
starting
position.
-11-