Keurig K35 - K35 Coffee Maker Setup; Before You Brew; Plug & Place; Rinse & Fill

Plug & Place
Remove packing tape from
coffee maker and plug into a
grounded outlet.
Place a large mug (295 ml/
10 oz. minimum) on the drip
trayplate.
Rinse & Fill
Remove the water reservoir lid, then lift
the reservoir straight up to remove it.
Rinse reservoir with fresh water and fill
to the MAX line.
Replace water reservoir, making sure
the lock tabs engage with the coffee
maker. Replace lid.
Power On
Press power button—the green power
light will illuminate.
The coffee maker will automatically begin
heating the water. This will take about
4minutes. Once the heating sound stops,
the coffee maker is ready.
Lift & Lower
Lift and lower the handle. Do not insert
a K-Cup® pod. The three brew buttons
will blink.
Press the small cup button to start a
cleansing brew. Pour the hot water into
the sink.
The one-time setup process is now
complete and you are ready to brew!
1
2
3 4
Before You Brew
Add Water