K-Cup® Pod Holder Assembly
To remove the K-Cup® pod holder from
the coffee maker, lift the handle and
grasp the top of the K-Cup® pod holder
with one hand while pushing up on
the bottom of the K-Cup® pod holder
from underneath with the other until
it releases. After cleaning, align the
K-Cup® pod holder with the opening
using the two front ribs as a guide and
snap into place from the top.
CAUTION: There are sharp needles that puncture the K-Cup® pod above the K-Cup® pod holder and in the
bottom of the K-Cup® pod holder. To avoid risk of injury, do not put your fingers in the K-Cup® pod holder.
Funnel
The funnel can be removed from the
K-Cup® pod holder by pulling on it until
it pops off. To replace it, just snap it
back onto the K-Cup® pod holder.
Exit Needle
Remove the pod holder assembly and
detach the funnel. Locate the exit
needle on the inside bottom of the
K-Cup® pod holder. Insert a straightened
paper clip into the exit needle to loosen
the clog and push it out.
Entrance Needle
Lift the brewer handle and locate the entrance needle on the
underside of the lid. To clean both holes in the needle, hold
the brewer handle in the upward position and with your other
hand, carefully insert a straightened paper clip into both
holes. Gently move it around to loosen any coffee grounds.
Lower the handle completely and run two water-only brew
cycles. Do not insert a K-Cup® pod.
To Next Page
Loading...
