Keyestudio 4WD - Page 262

262
www.keyestudio.com
 Dial power switch to ON end
 Connect micro:bit to computer by USB cable
 Open online Makecode editor
Import Hex profile (How to import?) , or click“New Project”and drag
blocks step by step(add MecanumRobot extension library first)
(How to add MecanumRobot extension?)
(4)Test Code:
Code1：
File Type
Path
File Name
Hex file
KS4031(4032) folder/Makecode
Tutorial/Makecode Code/Project
17.1：Detect Line Tracking
Sensor-1
Project 17.1：Detect
Line Tracking Sensor-1
Or you could edit code step by step in the editing area.
Click“Advanced”→“Serial”→“serial redirect to USB”
Place it into“on start”