(2)Experimental Preparation：
Insert micro:bit board into slot of keyestudio 4WD Mecanum Robot Car
Place batteries into battery holder
Dial power switch to ON end
Connect micro:bit to computer by USB cable
Open online Makecode editor
Import Hex profile (How to import?) , or click“New Project”and drag
blocks step by step(add MecanumRobot extension library first)
(How to add MecanumRobot extension?)
Warning: The 2-way tracking sensor should be used in environments
without infrared interference such as sunlight. Sunlight contains a lot of
invisible light, such as infrared and ultraviolet. In an environment with
strong sunlight, the 2-way tracking sensor cannot work properly.
(3)Flow Chart:
To Next Page
Loading...
