Keysight InfiniiVision 3000 X-Series Oscilloscopes User's Guide 7
For reference information, see: • Chapter 22, “Reference,” starting on page 325
When using licensed serial bus
triggering and decode features, see:
• Chapter 23, “CAN/LIN Triggering and Serial Decode,”
starting on page 345
• Chapter 24, “FlexRay Triggering and Serial Decode,”
starting on page 361
• Chapter 25, “I2C/SPI Triggering and Serial Decode,”
starting on page 371
• Chapter 26, “I2S Triggering and Serial Decode,”
starting on page 389
• Chapter 27, “MIL-STD-1553/ARINC 429 Triggering
and Serial Decode,” starting on page 399
• Chapter 28, “UART/RS232 Triggering and Serial
Decode,” starting on page 415
Abbreviated instructions for pressing a series of keys and softkeys
Instructions for pressing a series of keys are written in an abbreviated manner. Instructions for
pressing [Key1], then pressing Softkey2, then pressing Softkey3 are abbreviated as follows:
Press [Key1]> Softkey2 > Softkey3.
The keys may be a front panel [Key] or a Softkey. Softkeys are the six keys located directly
below the oscilloscope display.
To Next Page
Loading...
