Need help?Do you have a question about the Keysight Technologies InfiniiVision MSO-X 3034A and is the answer not in the manual?
General| Brand | Keysight Technologies |
|---|---|
| Model | InfiniiVision MSO-X 3034A |
| Category | Test Equipment |
| Language | English |
Details the procedure for compensating passive probes for accurate measurements.
Identifies and explains the functions of the oscilloscope's front panel controls and connectors.
Explains how to adjust the time/div scale and horizontal position (delay) of the waveform.
Guides on moving and expanding acquired waveforms in stopped or single acquisitions.
Explains how to search for events and navigate through captured time-base data.
Guides on setting the vertical sensitivity (volts/division) and position of waveforms.
Explains how to set input coupling (AC/DC) and impedance (50 Ohm/1M Ohm) for channels.
Covers setting probe options like attenuation, units, and calibration for analog channels.
Guides on displaying math waveforms and performing arithmetic operations or transforms.
Details available math operators (add, subtract, multiply) and transforms (differentiate, FFT).
Steps to save analog, math, or reference waveforms to internal memory locations.
Guides on saving and recalling reference waveform data to/from a USB storage device.
Step-by-step instructions for connecting digital probes to the device under test.
How to acquire waveforms and use AutoScale for digital channel display.
Guides on grouping digital channels and displaying them as a bus in hex or binary format.
Lists available serial decode options and their licensing, including CAN, LIN, FlexRay, I2C, SPI, I2S, MIL-STD, UART/RS232.
Explains how to use the Lister tool to view and investigate packet-level serial data.
Guides on using the search function to find and mark specific events within serial data.
How to change waveform intensity to improve visibility of signal details and noise.
Covers enabling and configuring persistence modes (Off, Infinite, Variable) for waveform display.
How to adjust the trigger level for analog/digital channels and force a trigger.
Configuration for Edge then Edge, Pulse Width, Pattern, OR, Rise/Fall, Nth Edge, Runt, Setup/Hold, Video, USB, Serial triggers.
How to choose between Auto and Normal trigger modes and understand their behavior.
Details Normal, Peak Detect, Averaging, and High Resolution acquisition modes for optimizing waveform capture.
Details specific voltage (Peak-Peak, Max, Min, etc.) and time (Period, Frequency, Rise Time, etc.) measurements.
Steps to automatically create a compliance mask from a reference waveform.
How to connect to the oscilloscope's LAN and access its web interface via a browser.
Setting up CAN triggers based on frame types, errors, and interpreting decoded CAN frames.
Setting up LIN triggers on sync break, frame ID, or data, and decoding LIN signals.
Setting up triggers for FlexRay frames, errors, and events.
Guides on setting up FlexRay serial decode and interpreting the decoded data display.
Guides on setting up I2C serial decode and interpreting the decoded data display.
Guides on setting up SPI serial decode and interpreting the decoded data display.
Setting up I2S triggers based on data values, qualifiers, and channel events.
Guides on setting up I2S serial decode and interpreting the decoded data display.
Guides on setting up MIL-STD-1553 serial decode and interpreting the decoded data and error displays.
Guides on setting up ARINC 429 serial decode and interpreting the decoded data display and color coding.
Setting up UART/RS232 triggers for start/stop bits, data bytes, and errors.
Guides on setting up UART/RS232 serial decode and interpreting the decoded data display.
To Next Page