14 Keysight M9036A Embedded Controller Startup Guide
Step 2: Verify Shipment Contents
Step 2: Verify Shipment Contents
Your shipment should have included the following:
- The Keysight M9036A Embedded Controller module that you ordered.
- This printed manual (M9036A PXIe Embedded Controller Startup Guide).
- An Automation-Ready CD with Keysight IO Libraries Suite (version 16.3 or
later). (IO Libraries was installed at the factory)
- An M9036A Product Information CD with User Guide and specifications.
Adobe Reader is required (http://get.adobe.com/reader)
- An ExpressCard latch kit. Refer to the User Guide for instructions.
- A GPIB cable and a DVI-to-VGA adapter were also supplied with the
controller (see photo below):
The operating system of your choice (Windows 7 32-bit or 64-bit, WES 7 32-bit
or 64-bit, or Windows XP 32-bit), the latest version of the Keysight IO Libraries
Suite, and all necessary driver software were installed for you at the factory.
No other drivers are required to operate the controller module. However, your
application modules may require drivers. If possible, you should connect the
M9036A to the internet and download drivers from the original source.
Alternately, you can transfer the drivers on a USB memory stick and install them
accordingly.
DVI-to-VGA
Adapter
GPIB Cable
Because there is no industry standard for the front micro D-sub
25P GPIB connector, interoperability cannot be guaranteed with
other similar cables. A replacement adapter cable may be ordered
from Keysight with the part number: M9036-31301.
The most current version of Keysight IO Libraries is required prior
to installing and running any other software. The latest version
can be downloaded from: www.keysight.com/find/iosuite.
To Next Page
Loading...
Need help?
General
