Keysight M9036A Embedded Controller Startup Guide 23
Step 5. Verify Operation
Step 5. Verify Operation
There are no actual verification procedures for the M9036A Embedded
Controller. If it boots properly and the front panel status LEDs do not indicate an
error (see “Front panel LED indicators” on page 11), then the controller is
working normally.
Note that you can use the Soft Front Panel (SFP) software to monitor and control
the triggering and the M9018A chassis function. To start the SFP programs, Click
the Windows Start button > All Programs > Keysight. Then select either the
M9018A or the M9036A. See the following screen capture.
To Next Page
Loading...
